This power pedestal is a vandal and weather resistant enclosure formed entirely from stainless steel with a #4 brushed finish. The utility landing section is located on the rear side with a removable panel for full access to the landing lugs. The landing lugs are made of aluminum using hex drive screws for tightening.
The 17 x 30 inch customer electrical compartment is located on the front and is capable of housing up to a 16 circuit load center with a removable dead front protective panel so that only the breaker switches are exposed. A stainless steel electrical backboard is provided for ease of wiring and grounding of electrical components. The customer compartment is outfitted with a continuously welded and hemmed, stainless steel door that uses a T-handle latching system.
All doors are equipped with water shedding drainage channels and provisions for a padlock, ensuring a watertight and vandal resistant design. This enclosure is NEMA 3R rated and UL 508A listed and complies with current NEC codes.
METER MOUNTING BASE – MPS, MPE, CSP, and DSP Meter Series | 100% Stainless Steel construction for long lasting durability and corrosion resistance.
Time Clock
MPS, CSP, and DSP Meter Series
Intermatic ET-Series | 1,2, and 4 channel options available
Photocells
MPS and CSP Meter Series
Ripley 6390TF with bypass switch included
Contact Block
MPS and CSP Meter Series
GE 30A Modular Contactors | 2P,4P,6P,8P,10P, and 12P options available
Two (2) GE Modular Contractors can be individually configured for two(2) to twelve(12) poles each
Branch Breakers
Contact factory for available options
In order to view the drawings, you must register with StrongBox.
